Charging Process - SATA trueSun Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 81
Notice!
If there is a fault in the charger / battery, please contact the SATA cus-
tomer service department (address see chapter 15).
The voltage and temperature of the battery are checked during charging.
The LED [1-12] provides information about the current charge status of
the battery.
The LED [1-13] indicates that the battery is ready for charging and also
indicates any possible defect in the charger.

Charging process

■ Connect the charger with the power supply using the power
plug [1-9] / [1-10] / [1-11] . Check the display mode of the LED [1-13]
(see following table).
■ Take the battery [1-7] our of the LED lamp ; to do so, press the release
catch [1-6] and release the battery.
■ Push the battery in the charging slot [1-8] of the charger .
■ Once the battery is fully charged, take it out of the charger (see follow-
ing table).
■ Insert the battery in the LED lamp; to do so, press the release catch on
the battery.
Display modes of the LEDs [1-12] and [1-13] on the charger
LED 1 [1-12]
green LED on permanently
green LED flashes
red LED is on permanently
red LED flashes
LED 2 [1-13]
red LED is on permanently
Operating Instructions SATA trueSun
battery is charging
battery is fully charged
battery is defective
Batteries whose tem-
perature falls below 0 °C
or exceeds 45 °C are not
charged.
charger is connected to
the power grid and is
ready
EN
75

Publicidad

Tabla de contenido
loading

Productos relacionados para SATA trueSun

Tabla de contenido