Steren CCTV-088 Manual De Instrucciones página 26

MODE
Scroll with the cursors up to the desired parameter; select it with
1
Modify the parameter with the cursors; save the change with
2
Scroll with the cursors until Return; press
3
If you install another
street front, change
the parameter to ON;
otherwise, keep it
OFF.
Set the type of
capture between
recording (Record)
or image capture
(Snapshot).
If the Record mode is selected, when someone rings the bell, a recording will be
automatically activated for 10 seconds. (A micro SD memory is required).
If the Snapshot mode is selected, when someone rings the bell, an image capture
will be taken.
ALARM
COLOR
Street front 1
Not enabled
11
It allows to configure the current working mode of the monitor, as
well as additional parameters.
This submenu is not enabled. It is recommended not to modify the
predefined parameters.
Allows you to adjust the details of the image on the monitor.
to exit.
Changes the monitor
mode between master
and slave. If there is
only one monitor, keep
the
Master.
Set
emission of the signal,
for the opening of the
sheet you install. The
range is from 1 to 10 s.
parameter in
the time of
Street front 2