Front View; General Description; Rear View - Bibby Scientific Stuart HM50C Instrucciones De Funcionamiento

Safety advice Before Use
 Never move or carry the unit while it is in use
or connected to the mains supply.
 Do not touch the heating element or any
glass vessel whilst in use.
 Only use flasks corresponding to the correct
capacity of your heating mantle.
 Do not use the heating mantle to heat
inflammable liquids.
 Do not immerse the unit in water or fluids.
 Always fill the glassware/vessel away from
the heating mantle and ensure there is no
liquid on the outside of the vessel before
placing it in the mantle. If spillage does
occur, disconnect from the mains supply and
follow the instructions as detailed in
Maintenance & Servicing.
 Do not cover the mantle while in use.
 Do not block or obstruct the ventilation slots.
 Do not leave the equipment switched on
without a charged flask.

general Description

The Stuart heating mantles have been specifically
designed for heating fluids in round bottomed
flasks. Heating control is provided by a built-in
solid state simmerstat (50, 100, 250 and 500ml
mantles) or an energy regulator (1000ml mantle).
The maximum element temperature is 450ºC.
The mantles are housed in an aluminium case
with stove paint finish to give good chemical
resistance. The units are provided with ventilation
slots in the base and around the rim to allow
convection cooling. All mantles also have a
support rod positioning clamp at the side of the
unit.
Controls

Front view

Heating element
Heating control
knob
Mains power
on indicator

Rear view

Hot surface warnings
Mains input IEC socket
Support rod
bracket
Heating element
on indicator
Refer to
instruction
manual label
Rating plate
Protective
conductor
terminator
3