Remington iLight IPL8500 Manual De Instrucciones página 9

F
Express Mode
Express Mode provides the user with a time friendly option for treatments. You may treat larger areas with this mode at
a faster rate, but it may be less effective and will take a few more treatments to see the desired results.
NOTE: Whenever the device is turned on, it automatically defaults to Power Mode (Full Power).
• If you wish to select an alternative mode, press and hold the desired button to illuminate it.
• Once you have decided and chosen which operating mode is right for you, put the treatment window firmly against
your skin.
• The device is now ready to trigger the first flash. To deselect the Sensitive or Express Mode, simply press the
selected button again and the unit will revert back to Power Mode with only the Flash Button illuminated.
C TREATMENT
CHANGING ATTACHMENTS
• Your i-LIGHT comes with two separate Treatment Caps.
• The Body Treatment Cap is for use on larger areas such as body hair.
• The Precision Treatment Cap is intended for use on smaller areas such as female facial hair, underarms and bikini
area.
To change attachments:
WARNING: Always ensure the unit is OFF and the power cord is disconnected before removing the Treatment Cap.
• Allow the system to cool down for 5 minutes before attempting to change the Treatment Cap
1. Turn the Power Switch OFF and unplug the Power Cord from the electrical outlet.
2. Hold the device with one hand while gently pulling the Treatment Cap with the other (Fig. 13).
NOTE: Treatment Caps are magnetically held onto the device and should pull off easily.
TIP: Store the unused Treatment Cap in a safe location taking care not to damage the flash window and other
components.
3. Gently push the other Treatment Cap back onto the device making sure it clicks into place.
How to treat:
1. Place the Flash Window firmly against the skin - ensure the Skin Contact Sensors are fully engaged. If the
Skin Contact Sensors are in full contact, the flash button on the device will pulse white and the LEDs on
the side of the hand piece will light up indicating the device is ready to flash.
NOTE: If the Skin Contact Sensors are NOT in full contact with the skin, the device will not operate if you press the
Flash Button and it will beep. Double check that the Skin Contact Sensors are in full contact with the skin.
2. Press the flash button to deliver a flash. You should expect to see a bright flash of light (similar to a camera flash)
and you should feel a mild sensation of warmth.
3. Move to the next area and treat in a grid like pattern to ensure full coverage of the treatment area.
• For single-flash mode, press the flash button each time you move to the next area.
• For multi-flash mode, keep your finger on the flash button to keep it depressed and glide to the next area being
sure to keep the Skin Contact Sensors fully engaged. The next flash will be delivered automatically after 3 seconds
(in Full Power Mode).
• During multi-flash mode if you let go of the flash button or lose skin contact, simply resume treatment by
repeating the above steps.
Facial Treatment (female use only)
Facial hair can be very different to body hair and the skin on the face tends to be sensitive and more likely to be
exposed to the sun's rays; therefore treating unwanted facial hair is different to treating the body – please be sure to
read the Warnings and Safety Precautions carefully before beginning a facial treatment.
IMPORTANT: The Precision Treatment Cap has been specially designed to treat the unique characteristics of female
facial hair. We would therefore advise against using the Body Treatment Cap on the face as this has been designed to
treat large areas below the neck. See section 'Changing Attachments' for more information.
The Precision Treatment Cap is intended for use on female facial hair on the cheek, sideburn, chin, neck area and above
the lips (Fig. 2). It can also be used on other smaller areas such as the underarms and bikini area.
DO NOT use on male beards or facial hair as the results may be permanent or uneven which may produce changes in
facial characteristics which may not be desirable.
ENGLISH
9