Additional Functions - Hughes & Kettner FSM 432 MK III Manual De Instrucciones

Assigning controller numbers
The assignation of functions (controller numbers) to the
two Control inputs works as follows:
• Control 1:
To access the edit mode, press and hold the
buttons Tap and D simultaneously until the
display shows the controller number and
the dot behind the second digit starts flashing. You can
now change the controller numbers using the Up/Down
buttons. Store the selected controller number by pressing
D. The dot stops flashing, and the FSM-432 returns to
normal mode.
• Control 2:
Press and hold Tap and C until the display
shows the controller number and the dot
behind the first digit starts flashing, then
release them. Change the controller number analogue to
the proceeding for Control 1. Store and exit with button C.

4 Additional Functions

The FSM-432 MK III offers even more functions. If you
press and hold Tap in combination with one of the four
preset buttons, you can access the following features:
• TAP + A = Bank direct mode
• TAP + B = Changeover to Stompbox Mode without
using the mode switch. To return to the Preset Mode,
press and hold TAP + B again or switch the FSM-432 off
and then back on.
• TAP + C = Edit controller number for Control 2, see
chapter 3.3. Factory default is controller number 64
(Boost).
• TAP + D = Edit controller number for Control 1, see
chapter 3.3. Factory default is controller number 07
(Volume).
You can access some additional features, if you press and
hold certain button combinations while switching the
GrandMeister 36 on using the "Power On" toggle:
• "Power On" + A = Change the MIDI channel of the FSM-
432 with the Up and Down buttons. Store and exit with
button A.
• "Power On" + TAP + Up = Factory reset of the FSM-
432. Press and hold TAP and Up until the display shows
a double eight incl. decimal point. Then release the
buttons. The individual segments of the display will
flash consecutively to indicate the successful factory
reset. After this, the starting sequence (see chapter 1)
follows.
• "Power On" + TAP + Down = Special function for
troubleshooting. In case operating your pedal doesn't
effect any changes on the amp, this mode can be used
to test the two Control inputs' proper functioning. The
display shows the position of the pedal in the context of
its total control range in percent (0-99%). The LEDs light
up from left to right with an increasing value.
Technical Data
Controller inputs 1 and 2
Midi In
Midi Out
External power supply
(optional)
Dimensions
Weight
All trademarks mentioned are the property of the respective owners.
FSM-432 MK III
6.3 mm (1/4") stereo jack
5-pin MIDI connector
Phantom powered 7-pin MIDI
connector
AC or DC 9-15 V / min. 250 mA
460 x 134 x 70 mm
1,7 kg / 3,7 lbs.
5