Service & Maintenance - Ferm FPCD-1800LK Manual De Instrucciones

GB
11-15: For driving screws into soft and medium-
density materials
16-20: For driving screws into hardwood
21-25: For driving large screws
Drill icon:
Hammer icon: For impact drilling
If material is particularly soft or porous,
set the torque clutch at a lower setting to
avoid overdriving the screw.
Adjusting the speed
Fig. 1
The appliance has two drill speeds.
• For slow drilling or for driving or removing
screws, set the speed selection switch (3) to
'1'.
• For fast drilling set the speed selection switch
to '2'.
Never switch over when the motor is
running!
Driving and removing screws
Fig. 1
• Set the direction reversing switch (8) to
position '' in order to drive screws.
• Set the direction reversing switch (8) to
position '' in order to remove screws.
Ensure that the direction reversing
switch (8) is always set to '' during
drilling.
Switching the device on and off
Fig. 1
• Depress the on/off switch (9). It regulates the
speed of the appliance by transmitting power
to the switch.
• Release the on/off switch (9) to halt the drill
chuck immediately, it will no longer run on.
• Move the direction reversing switch (8) to the
centre in order to lock the appliance in its
disabled state.
The drill will turn at its slowest speed when the
switch is depressed lightly. The drill will turn at its
fastest speed when the trigger is fully depressed.
Only lay down the appliance when it has stopped
running completely. Do not place it on a dusty
surface as particles of dust could get into the
mechanism.
8
For drilling
Spirit level
Fig. 8
The drill is equipped with a dual reading horizontal/
vertical level to assist in keeping the drill "level"
while drilling horizontal and vertical holes. The
horizontal level (21) is located in the top of the drill
housing. The vertical level (22) is located on the
rear of the drill housing.
To maintain a level drilling position, hold the drill
where the level bubble is centred in the level
indicator circle.
LCD display
Fig. 9
This combi drill is equipped with an LCD display
(4) on top of the drill housing
• To turn the display on, press the display button
(27) once. To turn the display off, press the
display button again.
• The light icon (25) will become visible when
the LED work lights are turned on.
• The clock (28) and minutes (24) remaining
icons indicate the number of minutes of
running time that are available before the
battery requires recharging (Lithium Ion
battery only)
• The battery icon (23) indicates the amount of
charge remaining in the battery. Each charge
bar displayed indicates approximately 10%
charge remaining in the battery. A total of 10
charge bars indicates a fully charged battery.
Dual LED work lights
Fig. 1 + 9
Dual LED lights (12) are located behind the torque
ring. The LED light switch button (26) is located
below the LCD display on top of the drill.
• To turn the LED lights on, press the LED light
switch once.
• To turn the LED lights off, press the LED light
switch again.
The display must be turned on first, in order for the
LED lights to work.
5. SERVICE & MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
Ferm