Kinderkraft Racoon Manual Del Usuario página 13

Thank you for your purchasing Kinderkraft product.
We create our products special for your child - we always take care of safety and quality to offer you
the best choice.
IMPORTANT, KEEP FOR FUTURE
USE, READ CAREFULLY
SAFETY INSTRUCTIONS AND PRECAUTIONS
WARNINGS
•
Remember about the risks related to open flames and other strong heat sources, such as
radiators/electric or gas heaters etc. near the product.
•
Do not place the bookcase near heat sources, windows.
•
Do not use the product if any of its parts is damaged, thorn or missing, use only original
manufacturer parts.
•
All assembly parts and frame shall be well tightened during the assembly and regularly checked
and tightened if necessary.
•
Do not leave children alone so that they do not climb on furniture.
•
Maximal load of the bookcase - 28 kg.
•
The product is not a toy.
•
Assembly the product in accordance with the following instructions. Incorrect assembly
increases the risk of accidents and damage.
•
To protect the product against falling over it should be used with the attached wall mounting
device.
1. List of parts - 3
2. Assembly of the bookcase:
Tools: Philips and flat-blade screwdriver. Do the assembly on a soft floor that will
not damage the surface of the parts. The product shall be assembled by two persons.
I. Start the assembly of the bookcase by placing the side wall of the bookcase (A)
and four beams (C) perpendicular to each other. Tighten the beams to the wall with
screws (1), considering the corresponding openings.
II. Lay two boards perpendicularly (E and H). The groove of the wider board shall be
directed to the floor. Pay attention to the openings. Then connect both boards with
screws (5).
III. Attach the connectors (2) and the studs (4) to the structure from 2. step. Pay attention to the
openings. The connectors (2) shall be inserted in such a manner that the bushings in the connectors are
compatible with the openings on the side surfaces of the board. Gently but stable fasten the studs (4) in
the board. Attach the whole structure to the set from 1. step with the screws (3). Lay the board (F) in
such a way that you can see the groove. Insert the connectors (2) in such a manner that the bushings in
the connectors are compatible with the openings on the side surfaces of the board.
Gently but stable fasten the studs (4) in the board. Attach the whole structure to the set from 1. step
with the screws (3).
13