EGO POWER+ CS1400 Manual Del Usuario página 34

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Underbucking
Begin on the underside of the log with the
top of the saw against the log; exert light
pressure upward. During underbucking,
the saw will tend to push back at you. Be
prepared for this reaction and hold the
saw firmly to maintain control.
◾ ◾
When the log is supported along its
entire length, it should be cut from
the top (overbucking) (Fig. 19).
◾ ◾
When the log is supported on only one
end, cut 1/3 the diameter from the
underside (underbucking). Then make
the finishing cut by overbucking to
meet the first cut (Fig. 20).
◾ ◾
When the log is supported on both
ends, cut 1/3 of that diameter
from the top overbuck. Then make
the finished cut by underbucking
the lower 2/3 to meet the first cut
(Fig. 21).
34
56V LITHIUM-ION CORDLESS CHAIN SAW
19
Log Supported Along the Entire Length
20
Log Supported One End
2nd Cut Overbuck (2/3 Diameter) to Meet 1st Cut
(To Avoid Pinching)
1st Cut Underbuck (1/3 Diameter) to Avoid Splintering
21
Log Supported Both Ends
1st Cut Overbuck (1/3 Diameter) to Avoid
Splintering
2nd Cut Underbuck (2/3 Diameter) to Meet 1st Cut
(To Avoid Pinching)
Cut From Top (Overbuck)
Avoid Cutting Earth

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido