Cleaning And Care - WMF Ambient Instrucciones De Uso

Cleaning and care

Before cleaning the aroma diffuser, you must first disconnect
the power and remove the cable from the appliance.
After each time you use the atomisation function, you must
empty the water tank by removing the lid and stainless steel
casing. Clean the lid and the water tank very thoroughly in
order to remove any germs that are in the water.
Fill the water tank with water and add a gentle washing-up
liquid or standard descaling agent. Clean the water tank
using the washing-up brush supplied in the delivery scope,
and rinse out the tank thoroughly with water. Then dry the
water tank using a cloth.
Never immerse the appliance in water! You can clean the
Cromargan® exterior using a slightly damp cloth.
Do not use any abrasive cleaning agents or sharp objects (this
can scratch the surface of the appliance).
For UK use only
▪ This product is supplied with a 13 A plug conforming to
BS 1363 fitted to the mains lead. If the plug is unsuitable
for your socket outlets or needs to be replaced, please
note the following. If the plug is a non-rewireable one,
cut it from the mains lead and immediately dispose of it.
Never insert it into a socket outlet as there is a very great
risk of an electric shock.
▪ The replacement of the plug at the mains lead has to be
done according to the following instructions:
Important: The wires in this mains lead are coloured in
accordance with the following code:
blue Neutral
brown Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
⋅ the wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black,
⋅ the wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
18
Do not connect any wire to the terminal which is marked
with the letter E or by the earth symbol
green or green and yellow.
▪ If a 13 A (BS 1363) plug is used it must be fitted with
a 13 A fuse conforming to BS 1362 and be ASTA
approved. If any other type of plug is used, the appli-
ance must be protected by a 10 A fuse either in the
plug or adapter or at the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse cover.
The appliance complies with European
directives 2014/35/EU, 2014/30/EU and
2009/125/EU.
At the end of its life, this product may not
be disposed of in normal household waste,
but must instead be taken to a collection
point for recycling electrical and electronic
appliances.
The materials are recyclable in accordance
with their labelling. Reuse, recycling and
other ways of reutilising old appliances
make an important contribution to
protecting our environment.
Please ask your local authorities for
information about the appropriate disposal
point.
End users are personally responsible for
deleting any personal data that may be
stored on appliances they are disposing of.
, or coloured
19