Standard Training Scenarios - Laerdal HeartStart FRx Trainer Instrucciones De Utilizacion

FRx Trainer 10-04-07 15:12
12
FRx TRAINER 861307
Page 12
3. Follow the FRx Trainer's voice instructions.
4. If using a clothed manikin, remove the clothing as instructed.
5. Open the Training Pads II case and peel off one pad.
NOTE: Avoid touching the pad's adhesive gel, because this may cause the Trainer to begin
analysis prematurely.
6. Place the pad on the manikin. Press
the pad down firmly.
Then peel and place the other pad.
7. Continue to follow the FRx Trainer's
instructions for remainder of scenario.
8. When the scenario has been completed,
or to stop a scenario in process, press
and hold the On/Off button until the
FRx Trainer turns off.
9. To repeat the same scenario, repack the pads as described in "To repack the
Training Pads II." Then begin again by pressing the green On/Off button.
To select a different scenario, press the i-button.
NOTE: If battery power is depleted, the FRx Trainer will say REPLACE BATTERY.The FRx
Trainer will continue to operate for a short time. Replace the batteries as soon as possible
to ensure correct Trainer behavior.

Standard training scenarios

The FRx Trainer provides eight training scenarios.When the Trainer directs you to
press the Shock button, the scenario will not advance unless the button is pressed.
When the Trainer detects a non-shockable rhythm, it instructs you to provide CPR
if needed.
In the Trainer scenarios, "conversion" means a change from a shockable to a
non-shockable rhythm.