BioLite KettleCharge Manual De Instrucciones página 6

Getting to Know Your KettleCharge
Smart LED Dashboard
Power Handle
Power Button
Spout Opening
USB Port
Handle Release Switch
Kettle Body
Baseplate
Flexible USB Extender
10 | English
Warning System LED
Heat Source Strength LED
Battery Charge Level LED
Power Button
(can also temporarily silence
audible warning system)
The BioLite KettleCharge is a unique device that
uses the heat differential between flame and water
to produce electricity to charge your devices while
simultaneously providing clean water. Before first use,
you must familiarize yourself with all component parts
and proper operation of the kettle.
The left-hand side with the flame icon represents the strength of your
heat source:
• The stronger the heat source, the more power will be generated.
• The four LED lights indicate temperature strength with one light being LOW
HEAT and all four lights being EXTREMELY HIGH HEAT.
• To prevent over-heating and damage of the electronics, the KettleCharge has a
built-in warning system that alerts you when the device is becoming too hot:
- When the top LED light on the left-hand side begins to blink this will signify
that you are approaching the upper temperature limit. Monitor closely.
- If the red triangle LED and all four heat LEDs begin to flash, accompanied by
a beeping sound, this indicates that the flame is too hot. Turn down heat
source. Beeping should stop within a few seconds.
- If the red triangle LED turns on, accompanied by a steady sound, this
indicates that the water is almost boiled away. Add water immediately.
- The power button can be used to temporarily silence the audible warning.
- If no action is taken when the warning system sounds, you may damage
your KettleCharge permanently.
The right-hand side with the battery icon
represents how much energy has been stored in
the internal battery:
• The BioLite KettleCharge features a special internal
battery designed to withstand high-temperature
environments while safely charging devices
• The battery is a lithium iron phosphate (LiFePO ),
4
1250mAh battery and each LED light indicates a 25%
charge. When all four lights are lit, the battery is full.
• The USB port is located at the bottom of the handle.
For more information, see the Charging section (pg 14)
All stoves and flames are different – closely monitor the
product when used with a new heat source.
WARNING
Exercise extreme care when plugging in
devices while boiling as the KettleCharge will
be hot and contact may burn or scald the user.
English | 11