Step 3: Charge; Step 4: Pour - BioLite KettleCharge Manual De Instrucciones

Step 3 - Charge
1. The KettleCharge produces 10 Watts of power (5V,2A). This energy is stored in a safe lithium iron
phosphate (LiFePO ), 1250mAh battery, providing a charge with or without being in use.
4
• 10 Watts is enough to charge headlamps, smartphones, GPS devices, cameras, and tablets. Please
check your electronics to ensure they are within the technical specifications (5V USB) for optimal
charging and protection of all devices.
2. When the first LED light turns on, real-time charging may begin. To charge while boiling, carefully attach
the USB extender to the Power Handle and position away from heat source. Attach your device's cord and
begin charging (fig. 1). Do not drape cords over the KettleCharge or rest electronics near the heat source
as the cords or electronics may be damaged by the heat.
3. When all four battery LED lights are green, the battery is fully charged. You may continue to charge a
device from the USB, but no additional power will be stored in the battery.
4. To charge when not boiling, ensure that the battery has been charged. If the KettleCharge is cool and
away from a heat source, activate the battery by pressing the power button (fig. 2). You may then plug
your devices directly into the Power Handle.
WARNING
Power Handle will be hot. A heat-resistant mitt or a sufficient fabric guard must be used when touching handle.
14 | English
2
Step 4 - Pour
1. When water is boiling, carefully remove USB extender from Power Handle (fig. 3). Lift
KettleCharge from heat source using a heat resistant mitt or a sufficient fabric guard and pour
1
into desired receptacle (fig. 4).
2. CAUTION - Bottom plate of KettleCharge will be extremely hot after use. When done boiling
and charging, rest KettleCharge on a non-flammable surface, ideally a metal or stone surface
or non-used burner and allow the KettleCharge to cool down. For fastest cooling, refill
KettleCharge with cold water.
3. To continue charging and boiling, refill KettleCharge with cool water, return to heat source, and
carefully reattach USB extender and device.
NOTE: Low water alarm may sound after pouring out water. To silence, push the Power Button.
Refill before next use.
2
WARNING
Use care when pouring boiling water. Contents will be extremely hot and can scald the user.
While the USB extender is designed to protect the internal cable from heat, surface areas can become very
hot. A heat-resistant mitt should be used when positioning or removing the extender.
3
4
English | 15