Step 1: Fill; Step 2: Heat - BioLite KettleCharge Manual De Instrucciones

Step 1 - Fill
1. Lift Power Handle into upright position.
2. Fill with water only (fig. 1).
3. Fill KettleCharge through spout opening. Use a faucet or water
bottle for best accuracy and to prevent spillage onto the device. Do
not submerge device into bodies of water such as a lake or river.
NEVER get handle wet.
WARNING
4. Do not overfill past the "MAX fill" line at 750ml. Overfilling may
result in water boiling over, which may scald the user (fig. 2a).
5. Always fill KettleCharge before placing over heat source.
12 | English
1
2a 2b
MAX fill MIN fill
2
Step 2 - Heat
1. Place the KettleCharge filled with water over a contained flame and center device to ensure even
heating and to protect the Power Handle.
2. CAUTION - Use care when placing KettleCharge on narrow diameter stove supports, such as
backpacking stoves. Monitor closely. Knocking over the KettleCharge while in use may burn and/or
scald the user.
3. Never allow water level to go below the MIN fill line. If this happens, warning system will sound –
fill with more water immediately (fig. 2b).
4. When the top LED lights on the left-hand side begin to blink, this signifies that you are approaching
the upper temperature limit. Monitor product and heat source closely.
5. If the red triangle LED and all four heat LEDs begin to flash, accompanied by a beeping sound,
this indicates that the flame is too hot. Turn down heat source. Beeping should stop within a
few seconds (fig. 3).
6. If the red triangle LED turns on, accompanied by a steady sound, this indicates that the water is
almost boiled away (fig. 4). Add water immediately.
7. If the KettleCharge does not stop beeping after one minute, remove from heat entirely.
8. When heating water for potability (drinkable), boil water vigorously for one minute; three minutes
if at altitudes of one mile or higher. If the water is cloudy, filter it through clean clothes or allow it
to settle and draw off the clear water for boiling. Allow water to cool and store in a clean container.
WARNING
NEVER PLACE KETTLECHARGE OVER A
LARGE OPEN FIRE. Such use presents a
risk of bodily injury and a safety hazard
to the user, the product, and to the
electronics being charged.
The KettleCharge will be extremely hot
when in use. Do not touch any part of
the KettleCharge with bare hands either
during or immediately after use.
3
flame is
too hot
4
water is almost
boiled away
English | 13