BTI MLL 360 Manual De Instrucciones página 11

Attention: The MLL 360° is a class 2 laser according to United States Government
Code Of Federal Regulations CFR21.
Do not look directly into the laser beam to avoid permanent eye damage.
Attention: Never charge the accumulators unattended.
Attention: Charge the accumulators according to their specifications.
Charging time is 4 hours, remove the charger afterwards!
Attention: Never short-circuit the accumulators!
Attention: Never break up the accumulatios nor expose them to heat or fire!
Warranty:
Warranty is 12 month on defect in material and workmanship. The warranty will not ap-
ply to this product if it has been altered or abused. Without limiting the forgoing, battery
leakage, damages to the plastic housing, broken optic windows, damage to the switch/
LED membrane are presumed to result from misuse or abuse. Tampering with or removal
of the caution or certifications labels voids this warranty. Attempts at repair or detectable
improper treatment will void any warranty claim. During the warranty period and upon proof
of purchase, the product will be replaced or repaired. All technical specifications of the
divece and accessories might be altered at any time and may differ from data sheets or
this manual.
In case of repair please send your defective MLL 360 ° to the BTI center. The recipient
address for this is:
BTI Befestigungstechnik GmbH&Co.KG - After Sales Service - Salzstraße 51 - DE 74653 Ingelfingen.
For queries about repairs contact us at phone number +49-(0)7940-141-874.
Safety instructions / Warranty
Laser class 2
CEI 60825-1 (2007)
≤ 1 mW ; 635 - 670 nm