Driving Guide, Driving Quality, Dial-A-Depth - Bostitch SF150C Manual De Operación Y De Mantenimiento

The driving guide should be placed against the work surface prior to
tool actuation. This insures the fastener is driven perpendicular to the
work surface.
The driving guide can be removed if desired:
1. Remove the pin that holds the driving guide
by using a 3/32" (2.4 mm) diameter punch. Fig.A
2. Slide the driving guide toward the nose. Fig.B
3. Gently tap the driving guide with a hammer
until it is removed from the track. Fig.C
4. The driving guide can be replaced by reversing the removal procedure.
Driving
Guide
DIAL-A-DEPTH
®
The DIAL-A-DEPTH Fastener control adjustment feature provides close
control of the fastener drive depth: from flush with the work surface to
shallow or deep countersink.
First set the air pressure for consistent drive in the specific work as
described on page 5, then use the DIAL-A-DEPTH
adjustment to give the desired depth of drive.
To get the most performance out of the SF150C and the STANLEY-BOSTITCH light gauge steel nails, the
following conditions should be met:
54-33 mil (1.37 mm - 0.84 mm)
gauge steel framing
Pin
Fig.A
®
Depth adjustment knob
Driving Guide
Fig.B
FASTENER CONTROL ADJUSTMENT
®
fastener control
1/2'' (13 mm) minimum penetration
- 9 -
DRIVING GUIDE
DRIVING QUALITY
Material being fastened
Fastener driven flush
No damage to
sheathing material
Fig.C