Dial-A-Depth - Bostitch SMART POINT BTFP72155 Manual De Operación Y De Mantenimiento

SELECTING THE TRIP MODE:
To ensure safety, the user must lock the trigger (as described above) before changing the trigger system.
To change the trip mode, rotate the mode switch toward the body of the tool. The mode switch will lock
automatically when the indicating arrow is pointing down to the 3 nail icon stamped into the tool frame
(Contact Trip Mode) or to a single nail icon stamped in the tool frame( Sequential Trip Mode). Unlock the
trigger to resume tool operation.

dIAl-A-dePTh

The DIAL-A-DEPTH
®
control of the fastener drive depth: from flush with the work surface to shallow
or deep countersink. First set the air pressure for consistent drive in the
specific work as described on page 7, then use the DIAL-A-DEPTH
control adjustment to give the desired depth of drive.
IN AddITION TO The OTheR WARNINGS CONTAINed IN ThIS
MANUAl OBSeRVe The FOllOWING FOR SAFe OPeRATION
• Use the BOSTITCH pneumatic tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user
or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function without approval from
BOSTITCH.
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Never clamp or tape the trigger or contact trip in an actuated position.
• Never leave a tool unattended with the air hose attached.
• Do not operate this tool if it does not contain a legible WARNING LABEL.
• Do not continue to use a tool that leaks air or does not function properly. Notify your nearest
BOSTITCH representative if your tool continues to experience functional problems.
Contact Trip Mode
(trip mode selector switch pointing down)
FASTeNeR CONTROl AdJUSTMeNT
®
Fastener control adjustment feature provides close
Sequential Trip Mode
(trip mode selector
switch pointing up)
fastener
®
Dial-A-Depth Fastener
®
Control Adjustment
-10-