Dial-A-Depth - Bostitch GF28WW Manual De Operación Y De Mantenimiento

DIAL-A-DEPTH™ FASTENER CONTROL ADJUSTMENT
Always disconnect fuel and battery before making adjustments or before attempting any
part assembly or disassembly.
The contact arm and nose will become hot after prolonged or rapid use. DO NOT TOUCH
with BARE HANDS, allow to cool or use gloves when adjusting a tool that is hot.
For GFN1564K, GFN1664K and GBT1850K
The DIAL-A-DEPTH™ Fastener control adjustment feature provides close control of the fastener drive depth:
from flush with the work surface to shallow or deep countersink.
1. Remove the fuel cell and battery from tool.
2. If nails are driving too deep, turn the adjustment knob to the shallow side.
3. If fasteners are not driven deep enough, turn to the deep side.
4. Adjustments are in half-turn increments.
5. Reconnect fuel cell and battery to test.
For GF28WW & GF33PT
1. Remove the fuel cell and battery from tool.
2. Loosen bolt on nose with provided hex wrench.
3. If nails are driving too deep, adjust the contact arm down.
4. If fasteners are not driven deep enough, adjust contact arm up.
5. Reconnect fuel cell and battery to test.
1
IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS
MANUAL OBSERVE THE FOLLOWING FOR SAFE OPERATION
• Use the BOSTITCH cordless tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user
or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle.
• Do not alter or modify this tool from the original design or function without approval from
BOSTITCH, INC.
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Never clamp or tape the trigger or contact arm in an actuated position.
• Never leave a tool unattended with the battery or fuel cell installed.
• Do not operate this tool if it does not contain a legible WARNING LABEL.
• Do not continue to use a tool that leaks fuel or does not function properly. Notify your nearest
Bostitch representative if your tool continues to experience functional problems.
2
Contact Arm
3
-14-