Ninja BL490EU Manual De Usuario página 27

1.2 L PROCESSOR BOWL
A B
If your unit comes with this accessory, read the following instructions. For a list of what is included with this model, refer to inside flap of the box.
CAUTION: CHOPPING BLADE IS
NOT LOCKED IN PLACE. IF USING
THE POUR SPOUT, ENSURE THE
LID IS FULLY LOCKED ONTO THE
BLEND AND PREP BOWL.
ASSEMBLY OF ASSEMBLY:
THE PROCESSOR
WARNING: NEVER LEAVE THE APPLIANCE
BOWL UNATTENDED WHILE IN USE.
CAUTION: USE CAUTION WHEN HANDLING
NOTE: Ninja Auto-iQ
® ®
THE CHOPPING BLADE AS IT IS VERY
Technology can sense
SHARP.
which jar is on the motor
IMPORTANT: MAKE SURE THE MOTOR BASE
base. The function lights
IS PLUGGED IN FOR USE.
will illuminate depending
on which container is
1 Holding the desired blade by the top of the shaft,
placed on the motor base.
place it onto the drive gear (A) inside the bowl.
Ensure that the attachment is seated properly
and is standing upright.
NOTE: THE CHOPPING BLADE WILL FIT
LOOSELY ON THE DRIVE GEAR.
®
C D
ASSEMBLY
CAUTION: THE CHOPPING BLADE
IS NOT LOCKED IN PLACE.
IF POURING WITH THE LID
REMOVED, ALWAYS REMOVE THE
CHOPPING BLADE FIRST.
2 Place the motor base on a clean, dry, level
surface such as a counter or tabletop. Press down
on the motor base to make sure that the suction
cups adhere to the counter or tabletop.
3 Align and lower the Processor Bowl (B) onto the
motor base. Handle should be aligned slightly to
the right of the LOCK symbol on the motor base.
4 Rotate the Processor Bowl clockwise (C) until it
locks in place (you will hear a click when the lock
is engaged).
5 The bowl can be placed on the motor base two
ways; the handle can be on the front right corner
(D) or the front left corner (E).
or
E F
IMPORTANT: DO NOT OVERFILL.
TO AVOID SPILLING, DO NOT
ADD INGREDIENTS PAST THE
"MAX" FILL LINE.
6 Add the ingredients to the bowl, making sure
they do not exceed the highest measured marking
line on the side of the bowl.
7
Holding the lid by the handle in the upright
position (F), place it on top of the bowl aligning
the triangle ( ) located on the lid with the
triangle ( ) located on the bowl handle. Press the
handle down until you hear a click.
8
The triangles on the lid and the Processor Bowl
handle (G) MUST be aligned for the blender to
turn on.
9 Plug the power cord into the electrical outlet. The
function lights will illuminate.
G
2 7