5.
The hair, which you will cut must be clean.
6.
Insert a desired comb on the cutting head. The comb must snap to properly hold in place. When selecting
the size of attachment, follow the signs listed on the boxes.
7.
Turn the device on (position ON).
8.
Start with a longer hair comb and then use as needed a comb for shorter haircut.
9.
Proceed slowly against the direction of the hair growth.
10. While cutting, hold the comb as straight as possible.
11. Using the lever to adjust the blades, you can change the height of the cutting even without changing the
combs.
12. You can also use the device without a comb and obtain the lowest possible height of the haircut.
13. Switch the device off immediately after use.
Notes:
•
Before you start cutting hair, turn the clipper on by turning the switch to position 1 and make sure that the
device is working properly and the blades move smoothly.
•
Always turn off the clipper when you pause cutting.
•
Always switch the clipper off and unplug it before changing an attachment.
GB
Tips for a better haircut:
•
Sit the person, whose hair you are cutting so that her head is at your eye level, cover her shoulders with
a towel and style her hair using a comb.
•
Always start haircut from the back side of the head.
•
To let your hair longer, take a strand of hair between the fingers and cut the hair using the clipper.
•
Cut only a small amount of hair at a time you can return to the trimmed place later and possibly cut more.
•
Comb through hair to uncover unevenly trimmed strands.
•
You can lift the hair using comb and cut it along the comb.
•
Even the haircut using scissors.
•
You will learn over time to model a perfect desired hairstyle.
CLEANING AND MAINTENANCE
•
Turn the device off and unplug it from the outlet.
•
Use the supplied cleaning brush to clean the cutting head.
•
Never use water or other liquid to clean the cutting head.
•
After each use, we recommend to lubricate lightly the moving teeth of the cutting edges with silicone oil.
You can use the supplied oil. After you apply the oil, plug the clipper in and let it run for 2–3 seconds so that
the whole mechanism is well lubricated. Do not disassemble the head with blades.
•
Use only acid free oil.
•
Wipe off the excess oil with a cloth.
•
DO NOT USE vegetable oils, fat or oils with solvents for lubrication. The solvents evaporate and leave
a thick layer of grease, which can slow down the movement of the blades.
TECHNICAL SPECIFICATIONS
Nominal voltage:
Nominal input power:
Noise level:
NOTE: The following situations void the warranty:
Incorrect or inappropriate handling of the device, failure to observe safety measures applicable to the device, the use of force,
alterations or repairs made by a party other than an authorized service centre.
Components subject to normal wear and tear are not covered under the warranty.
26
220–240 V ~ 50 Hz
8 W
≤ 72 dB