Important Safeguards; Operating Instructions - Elite VC0850P Manual De Usuario

IMPORTANT SAFEGUARDS

The symbol on the product or packaging indicates that the product must not be treated as domestic refuse.
Instead, it should be handed in to a collection point for the recycling of electrical and electronic compo-
nents. By ensuring the product is treated in the correct manner, you will help prevent any negative impact
on the environment and health that might arise were the product to be discarded as ordinary refuse. For
further information about recycling, you should contact your local authorities, refuse collection service or
the sales outlet where you bought the goods.
WARNING!
This product or its power cord may contain chemicals, including lead, known to the state of California to
cause cancer and birth defects or other reproductive harm. Wash hands after handling.

OPERATING INSTRUCTIONS

WARNING:
To reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases, vapors or
explosive dust in the air. Flammable gases or vapors include but are not limited to: lighter fluid, solvent-type
cleaners, oil-based paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited
to: coal, magnesium, aluminum, and grain or gun powder. Do not vacuum explosive dust, flammable or
combustible liquids or hot ashes. Do not use this vac as a sprayer for any flammable or combustible liquid.
To reduce the risk of health hazards from vapors or dusts, do not vacuum toxic materials.
WARNING:
The operation of any utility vac can result in foreign objects being blown into the eyes, which can result in
severe eye damage. Always wear safety eyewear complying with ANSI Z87.1 (or in Canada, CSA Z94.3)
before starting operation.
CAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vac for extended hours or when
using it in a noisy area. This 12-gallon wet/dry vac is assembled at the factory and ready for use when you
remove it from the carton. The unit is ready for dry vacuuming or blowing. After you plug the power cord
into the wall receptacle, turn the unit "ON" by pushing the switch from position "O" to position "I". The "O"
is the "OFF" position and the "I" is the "ON" position.
5
www.ELITETOOLS.co
Keep Working