Stadler Form Viktor Manual De Instrucciones página 7

Timer The appliance switches off automatically after 2, 4 or 8 hours as you
wish. Ideal for air purification when you leave the home but would like to
have the air purified in your absence. The appliance can also be used with-
out the timer and is suitable for continuous operation.
Night mode Today, many appliances incorporate LED lights which are un-
suitable for night-time use in a bedroom. In night mode, the light intensity is
reduced to a pleasant level.
Preparation for use/operation
1. Place the Viktor air purifier on a flat surface in the desired area. Plug the
adaptor (3) into a suitable electric socket.
2. Open the appliance on the back side (by pressing on the labelling «Push to
open»). Remove the protective membrane from the activated carbon filter
(13). Please check whether the locking elements of the HPP™ filter (14) are
in a horizontal position (as shown in the figure). If this is not the case, please
move them until the locking elements are in a horizontal position to secure
the HPP™ filter.
3. Then switch on the appliance by pressing the on/off switch (5).
4. You can adjust the speed and thus the purification rate (volume per hour) by
pressing the speed level selector switch (6) (one blue lamp for level 1, two
blue lamps for level 2, etc.).
5. You can use the timer to set the desired cleaning time. To do this, press on
the timer button (7). You can choose between the following periods: 2 hours,
4 hours or 8 hours. If you do not wish to use the timer, you may run the air
purifier in continuous operation (no LED lamps illuminated).
6. If you find the lamps too bright (in a bedroom for example), you may reduce
the light intensity by pressing the night mode key (9). You can choose be-
tween three different modes:
• Normal mode (default mode)
• Dimmed mode (push once)
• Lights-out mode (push twice)
• By pushing the dimmer button once more, you can go back into normal
mode.
7. You may use the Viktor air purifier to distribute fragrances in the room.
Please be as economical as possible in the use of fragrances, because ex-
cessive quantities may lead to malfunctions and damage to the appliance.
To use fragrances, remove the fragrance container (10) from its mounting.
Place no more than 1-2 drops of fragrance in the container and replace it in
its designated position. If you wish to change the fragrance, you can wash
out the fragrance container and fleece under running water.
Cleaning
Prior to any maintenance work and after each use, switch off the appliance
and withdraw the adaptor from the socket.
Attention: Never immerse in water (risk of short circuit).
• External surfaces should only be wiped off with a damp cloth and then
dried well.
• The preliminary filter can be cleaned carefully with a vacuum cleaner. The
filter should be changed at 6 month intervals.