Kerbl FastHeat Instrucciones De Uso página 8

DE FastHeat – Calf Milk Warmer with Convection Heating
EN
1. General Notes
These operating and safety instructions are intended for the user. Please read the instructions carefully and adhere to the
regulations and notes before operating the device.
2. Purpose / Correct Usage
The calf milk warmer is designed for the warming of milk and feed that has been prepared with water. The calf milk
warmer may not be used for other purposes, specifically the prevention of the freezing of water in feed troughs and the
warming of aggressive liquids.
3. Safety Notes
• Use: The warranty and liability of the manufacturer do not apply in the event of incorrect use of or interference with
the device. The voltage information on the type plate must conform to the voltage of the power supply.
• Please check all components before each use. Damaged parts may only be repaired by specialists or by the manufactu-
rer. If repairs are carried out incorrectly or the user fails to carry out repairs then this can cause operator accidents. Do
not operate the device if it or one of its components is defective. Always use original spare parts for any repairs.
• Safety : Always pull the mains plug out first before cleaning, adjusting or maintaining the device.
• Protect the connection lines: Do not use the connection line to pull the power plug or to carry the device. Ensure that
the connection lines do not come into contact with heat, oil or sharp edges. Damaged connection lines can cause fires,
short circuits and electrical shocks. If the connection line on this device is damaged then it must be replaced with a
specific connection line, available from the manufacturer or their customer service representative.
• Regular maintenance: Always keep the device in a dry, safe place, out of the reach of children. Please adhere to any
maintenance requirements. Check your device at regular intervals. Only use original accessories and spare parts.
• National and international regulations: Please adhere to national and international safety, health and work safety regu-
lations.
• Disconnect unit from the mains: The unit must be disconnected from the mains after use. The unit is not switched off
and thus disconnected from the mains if the power cable remains attached to the socket.
• Do not operate the device near explosive substance or atmospheres at risk of explosion.
• Regularly check the device for leaks (seals, cable conduits and screw attachments). Neglecting this check can result in
significant danger.
• The device must not be operated via an external timer or a separate remote action system.
4. Operating Instructions
4.1. Submerge the heating element on the calf milk warmer in the liquid that you wish to warm. Please note the maxi-
mum submersion depth, shown by the groove on the upper end of the submersion pipe. Do not exceed this level.
The heating ring must be fully submerged in the liquid and the handle must never come into contact with the
liquid. The container must be made of heat-resistant material. Never use plastic containers!
Do not exceed maximum submersion depth! (level marked „max.", see diagram on page 3)
Do not submerge below minimum submersion depth! (level marked „min.", see diagram on page 3)
4.2. Plug the mains plug into a socket that was installed by a recognised specialist and that is fitted with a fault circuit
interrupter (FI) with an operating current of 30 mA. From now on the liquid may not be touched!
4.3. Set the desired temperature on the thermostat. ( 0 ) corresponds to the minimum temperature (
temperature of approximately 40°C and (
lamp is on during the heating phase.
) denotes a temperature of approximately 80°C. The red control
8
) denotes a