Connecting A Printer; Connecting Input Devices; Connecting A Network Peripheral; Connecting The Line Voltage - HEIDENHAIN ND 7000 Manual De Instrucciones

Pin layout of X104
Further information: "X104", Page 188
Pin layout of X 105
Further information: "X105", Page 189
Pin layout of X 106
Further information: "X106", Page 189
5.7

Connecting a printer

Connecting a USB printer
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the device",
Page 22
Connect USB printer to USB type A connection (X32).
Make sure the USB cable connector is fully inserted
Further information: "Product overview", Page 25
Pin layout of X32,
Further information: "USB", Page 188
Connecting an Ethernet printer
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the device",
Page 22
Connect the Ethernet printer to the Ethernet port X116
using a standard CAT.5 cable. The cable connector
must firmly engage in the port
Further information: "Product overview", Page 25
Pin layout of X116
Further information: "RJ45", Page 190
5.8

Connecting input devices

Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the device",
Page 22
Connect USB mouse or USB keyboard to USB type A
connection (X32). Make sure the USB cable connector
is fully inserted
Further information: "Product overview", Page 25
Pin layout X32
Further information: "USB", Page 188
26
5.9

Connecting a network peripheral

Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the device", Page 22
Connect the network peripheral to Ethernet port X116
using a standard CAT.5 cable. The cable connector
must firmly engage in the port
Further information: "Product overview", Page 25
Pin layout of X116
Further information: "RJ45", Page 190

5.10 Connecting the line voltage

WARNING
Risk of electric shock!
Improper grounding of electrical devices may result in
serious personal injury or death by electric shock.
Always use 3-wire power cables
Make sure the ground wire is correctly connected to
the ground of the building's electrical installations
WARNING
Fire hazard due to wrong power cable!
Use of a power cable that does not meet the
requirements of the mounting location may cause a fire
hazard.
Use only a power cable that meets at least the
national requirements of the respective country in
which the product is mounted
Use a power cable that meets the requirements to
connect the power connection to a 3-wire grounded
power outlet
Further information: "Product overview", Page 25
Pin layout X100
Further information: "X100", Page 188
HEIDENHAIN | ND 7000 | Installationsanleitung | 05/2018