Connecting A Printer; Connecting Input Devices; Connecting The Line Voltage; Connecting A Network Peripheral - HEIDENHAIN POSITIP 8000 Manual De Instrucciones

5.7

Connecting a printer

Connecting a USB printer
Comply with the pin layout
Further information: "USB", Page 193
Remove and save the dust protection caps
Route the cables based on the mounting variant
Further information: "Assembly of the product", Page 24
Connect USB printer to USB Type-A port (X31, X32,
X33, X34). Make sure the USB cable connector is fully
inserted
Further information: "Product overview", Page 26
Connecting an Ethernet printer
the following pin layout
Further information: "RJ45", Page 196
Remove and save the dust protection caps
Route the cables based on the mounting variant
Further information: "Assembly of the product", Page 24
Connect the Ethernet printer to the Ethernet port X116
using a standard CAT.5 cable. The cable connector
must firmly engage in the port
Further information: "Product overview", Page 26
5.8

Connecting input devices

Comply with the pin layout
Further information: "USB", Page 193
Remove and save the dust protection caps
Route the cables based on the mounting variant
Further information: "Assembly of the product", Page 24
Connect USB mouse or USB keyboard to USB Type-
A port (X31, X32, X33, X34). Make sure the USB cable
connector is fully inserted
Further information: "Product overview", Page 26
5.9

Connecting a network peripheral

the following pin layout
Further information: "RJ45", Page 196
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the product", Page 24
Connect the network peripheral to Ethernet port X116
using a standard CAT.5 cable. The cable connector
must firmly engage in the port
Further information: "Product overview", Page 26
28

5.10 Connecting the line voltage

WARNING
Risk of electric shock!
Improper grounding of electrical devices may result in
serious personal injury or death by electric shock.
Always use 3-wire power cables
Make sure the ground wire is correctly connected to
the ground of the building's electrical installations
WARNING
Fire hazard due to wrong power cable!
Use of a power cable that does not meet the
requirements of the mounting location may cause a fire
hazard.
Use only a power cable that meets at least the
national requirements of the respective country in
which the product is mounted
Comply with the pin layout
Further information: "X100", Page 193
Connect the power connection to a 3-wire grounded
power outlet using a power cable that meets
requirements
Further information: "Product overview", Page 26
HEIDENHAIN | POSITIP 8000 | Installationsanleitung | 09/2018