Adjusting The Temperature; Manual Defrost - Polar GG216 Manual De Instrucciones

UK
Installation
Note: If the appliance has
been stored or moved in a
non-vertical position, stand
it in an upright position for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning, maintain a distance of 20cm
(7 inches) between the appliance and walls or
other objects for ventilation. NEVER LOCATE
NEXT TO OR NEAR A HEAT SOURCE.
Note: Maximum load of shelves
is 15kg
Operation
Control Panel
4
GG216_GG218 _ML_A5_v3_170620.indb 4
LCD Display
Cabinet Temperature Display
Glass Heater On
Evaporator Fan On
Compressor On
Control Buttons

Manual Defrost

Down Button
On / Off
Up Button
Glass Heater
Light Switch
To switch refrigeration system on or off press
and hold for 3 seconds

Adjusting the Temperature

1. Press button for 1 second.
display will flash.
2. Press up button or down button
change the set temperature.
3. Wait 6 seconds for the set temperature to be
stored.
Manual Defrost
1. To start manual defrost press defrost button
and hold for 6 seconds.
2. To stop manual or automatic defrost press
defrost button .
Glass Heater
• To turn on Glass Heater press Glass Heater
button for 3 seconds. Display will show
• To switch off Glass Heater press Glass Heater
button for 3 seconds.
on the LCD
to
.
2017/6/20 09:46