Installation; Power Supply To The Handset; Connection To The Telephone Line; Fitting The Batteries - BRONDI DC6010TR Manual De Instrucciones

CAUTION!
The electric socket must be fi tted near the handset and must be easily acessible.
1. Insert the plug positioned at one end of the adapter cable provided into the appropriate
power socket at the back of the base.
2. Insert the adapter plug into the electric socket on the wall.
1. Insert the plug positioned at one end of the telephone cable provided into the
appropriate socket at the back of the base.
2. Insert the tripolar telephone plug into the telephone socket on the wall.
1. Position the cordless with the buttons facing down.
2. Unhook the cover of the battery compartment on the cordless, pressing the cover and
pulling it towards you.
3. Insert the 2 batteries (ministilo AAA) into the compartment, respecting the polarity
indicated inside.
4. Close the battery compartment, sliding the cover upwards.
CAUTION!
BEFORE USING THE HANDSET, WE RECOMMEND TO LETY THE CORDLESS UNDER CHARGE AT LEAST
DURING 15 HOURS IN THE APPROPRIATE COMPARTMENT OF THE BASE, TO ALLOW A COMPLETE
CHARGE OF THE BATTERIES.
When the cordless batteries run down (i.and. you see on the display the symbol
the cordless in the appropriate compartment of the base with the buttons facing you.
Recharge it for 15 hours to fully recharge the batteries.
CAUTION: Only use recyclable batteries dedicated to this model. When the cordless
autonomy time begins to drop, even if the batteries have been correctly recharged, the
batteries are running down and must be replaced: follow the instructions in paragraph

"5.3 Fitting the batteries".

DC6010TR-lingue
5. I
NSTALLATION

5.1 POWER SUPPLY TO THE HANDSET

5.2 CONNECTION TO THE TELEPHONE LINE

5.3 FITTING THE BATTERIES

5.4 RECHARGING THE BATTERIES

5.5 REPLACING THE BATTERIES

10
10
) just rest
28-10-2005, 14:14