Remote Control Mode: Tv Controls; Warranty; Ce Conformity Declaration - BRONDI DC6010TR Manual De Instrucciones

3. Wait some seconds:
a. if the display of the cordless shows "
was successful, and you can proceed with another control (repeat the procedure fron
step 1.and.);
b. otherwise, if the display shows "
successful, and you must repeat the learning procedure for the same control that has
given an error, in our example CH+ (channel up).
c. if nothing occurs, check the remote control function and repeat the procedure from
step 1.e.
4. At the end of the procedure, press the button MENU to leave programming.
After confi guring the cordless, to use it as a TV remote control you must enter the mode
REMOTE CONTROL preswsing the red button TV.
In this mode, the display shows "
shall be automatically deactivated, and you can answer.
See section 3. DESCRIPTION OF THE CORDLESS to see the TV controls to be activated through
the buttons of your cordless phone.
Pressing again the red button TV, lthe mode REMOTE CONTROL shall be deactivated, and
the cordless returns to stand-by.
Like all Brondi products, this product has a 12-month warranty. The packing of the DC6010TR
contains a special warranty card. For the warranty to be valid:
• the card must be completely fi lled in;
the the card must be accompanied by proof of purchase (receipt or invoice, etc.);
• the packaging must be undamaged.
To correctly fi ll in the card, print the name of the product purchased (DC6010TR) and the
serial number (SN) printed under the base of the phone (if this is not already printed on the
waranty card).
Brondi reserves the right of modifying without notice the specifi cations and performance of
the product.
Brondi Telefonia S.p.A., with registered offi ces in Str. Caffadio 14 – 10036
Settimo Torinese (TO) and operatine unit in Via Guido Rossa 3 – 10024 Moncalieri (TO), declares
that the DC6010TR meets the requirements of European Directive 1999/5/CE regarding radio
equipment and telecommunications terminals and is conformant to the following standards:
EN 301 406 V1.4.1, EN 301 489 - 01 V1.3.1, EN 301 489 - 06, EN 60950:2000.
Conformity to these requirements ids expressed with the mark.
The DC6010TR has been designed and constructed for use in connection with the Italian
PSTN analogue telephone network. Product conforming to EEC Directive 89/336/CEE related
to the electromagnetic compatibility and also conforming to EEC Directive 73/23/CEE (low
voltage) related to safety regulations.
DC6010TR-lingue
Success
" and then "
Fail

8.3 REMOTE CONTROL MODE: TV CONTROLS

" and the icon
TV Control
9. W
ARRANTY
10. C
E CONFORMITY DECLARATION
20
20
" and then "
Press a key
", learning was not
Press a key
. When a callll arrives, the mode
TV
28-10-2005, 14:14
", learning