Clatronic BS 1229 Instrucciones De Servicio página 40

4....-05-BS 1229
Nozzle accessories
GB
Crevice nozzle long and
short, brush attachment:
Floor nozzle:
Please note that the floor nozzle is a "2 in 1" attachment. For smooth floors please
use the floor nozzle without the attachment. Remove the attachment on the bottom
of the floor nozzle by releasing the locking mechanisms and pressing them
upwards at the same time.
Damper
Open the damper on the hose handle to adjust the airflow or to release objects clin-
ging to the nozzle.
Filter:
Your vacuum cleaner has three filters.
1. Main filter (in the dust container)
• As your vacuum cleaner has a filter which you can remove and wash, there is
no need for you to purchase replacement dust backs.
• Open the dust container. Take out the filter insert. Empty the contents of the
dust container and clean the main filter by knocking it against an object.
• Stubborn dirt can be removed by passing water against the direction of airflow
through the filter fabric.
• Only replace the filter insert when it is completely dry!
2. Motor protection filter (inlet filter):
• The inlet filter is located in the dust container.
• The filter is in a vertical position in the rear section of the dust housing.
• Pull the filter out at the front. Clean the motor protection filter approximately
every tenth time the vacuum cleaner is emptied. If necessary, the filter can also
be washed in warm water without any additives.
• Place it back into place only once it is completely dry!
3. Outlet filter:
• The appliance is also equipped with an outlet filter.
• You will find this filter on the right-hand side of your vacuum behind a ventilation
grid.
• Open the ventilation grid by pulling the lever above the ventilation grid.
• Remove the filter and clean as described above.
• Fit the filter back into place and close the ventilation grid by following the steps
above in the opposite order.
40
10.09.2003 2:52 Uhr
To vacuum corners and slits
For cleaning carpets or smooth surfaces.
Seite 40