afx light DMX512-PRO Manual De Instrucciones página 15

1. Call the programming mode. For this, keep the REC pressed until the LED above
the button lights.
2. Press the button SCENE.
• The control LED lights.
3. Keep the button DEL pressed and select the scene to be deleted with the number
buttons 1-16.
• The control LEDs of the memory banks containing data light.
• If necessary, use the button PAGE to switch between the two channel groups 1-16
(LED A lights) and 17-32 (LED B lights).
• To confirm the deleting procedure, all LEDs of the controller flash three times.
4. After the desired scene has been deleted, switch off the programming mode. For
this, keep the button REC pressed until the LED above the button lights.
Programming and Memorizing Chases
For programming chases (sequences of scenes), 32 memory banks are available. A
sequence of up to 100 steps can be programmed on each memory bank. Previously
memorized scenes may also be compiled to a chase in any desired order. Chases may
run automatically, manually, or sound-controlled.
Fig. 7.8 Programming mode
1. Call the programming mode. For this, keep the REC pressed until the LED above
the button lights.
2. Press the button CHASE.
• The control LED lights.
Fig. 7.9 Programming a chase
3. Select the desired memory bank with one of the number buttons 1-16.
• If necessary, use the button PAGE to switch between the two channel groups 1-16
(LED A lights) and 17-32 (LED B lights).
• The display indicates e.g. "Chase01 Step001" in the lower line.
4. Press the button FIXTURE.
• The control LED lights.
5. Use the number buttons 1-16 to select the devices to be controlled.
©Copyright Lotronic 2018
Program
Program
Chase01 Step001
Manual DMX512-PRO 15