afx light DMX512-PRO Manual De Instrucciones página 8

Manual Assignment of DMX Starting Addresses
It is possible to individually assign the DMX starting addresses to the controller. The
assignment can be made in the system settings.
1. Switch on the controller with the rear power switch. The unit is in manual mode
and the display indicates "Manual" in the upper line.
2. Keep the button MENU pressed for 2 seconds to call the system settings.
3. The display indicates the first menu item „01.Patch fixture"(otherwise select it
with the pan wheel). Press the button ENTER to begin with the configuration. The
display indicates "PLEASE SELECT FIXTURE".
4. Use the buttons number buttons 1-16 to select the unit of which the DMX starting
address is to be assigned (control LED lights).
5. This menu item allows adjusting further characteristics. Use the button SWAP to
switch between the options.
6. Select the option DMX START ADDR to assign the DMX starting address. The
display indicates "NO PATCH ADDRESS" in case no assignment was made yet;
otherwise it indicates e.g. "ADR: 001".
DMX START ADDR
Fig. 6.1 Manual address assignment
FX:01 ADR:001
7. Change the address with the pan wheel. For addresses that were already assigned,
the display inserts a "!".
8. Press the button ENTER to memorize your setting.
• To confirm the memory procedure, all LEDs of the controller flash three times.
9. Repeat the steps 4, 7 and 8 to assign further units.
10. After your settings, exit the system settings. For this, keep the button MENU
pressed for 2 seconds.
Manual Assignment of DMX Channels
It is possible to individually assign the DMX channels of the connected light effect
units to the control elements of the controller (softpatch). However, some DMX
channels must be assigned according to a certain scheme, in order for the controller
to correctly perform the integrated movement patterns, color effects and fade
effects. For control of the pan/tilt function of moving heads or scanners, the
corresponding DMX channels must be assigned e.g. to the pan and tilt wheel; and for
control of RGBW light effect units, the DMX channels which control red, green, blue,
white and the dimmer function, must be assigned to the sliding control 1-5. The
assignment can be made in the system settings.
1. Keep the button MENU pressed for 2 seconds to call the system settings.
©Copyright Lotronic 2018 Manual DMX512-PRO 8