Ega Master MASTERMATIC-2 Manual De Instrucciones página 5

3. Clockwise direction threading (slow speed): the mechanical switch must be in FOR.
Clockwise direction unthreading (fast speed): the mechanical switch must be in REV.
4. Insert the machine on to the pipe and make sure that the support is securely guided into its
housing located on the machine.
5. When starting the threading, push slightly the head against the pipe.
6. Use oil abundantly when threading to improve the life and quality of the thread.
1
4
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the machine
being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed number.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones must
be collected and arranged separately. If you have to throw them out, please, do not use the usual
rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
2
5
NOTES
GUARANTEE
3
6
5