Charging The Battery; Use - Genius INVICTUS X9 Instrucciones De Uso

Assembling the charging station
1. Place the holder on the recess on the front of the storage station.
2. Tighten the bracket with the included screw.

Charging the battery

NOTE!
Charge the battery with the supplied charging
cable only. Always use original batteries.
1. Ensure that the appliance cleaner is switched off.
2. To charge the battery, connect the charging socket (k) to a suitable power outlet using the mains adapter
(fig. D).
Or
Remove the battery from the main unit by pressing the release button (o) at the end of the battery and pulling it
out (fig. E). Connect the storage unit to a suitable power outlet using the included mains adapter and insert the
battery in the appropriate recess (fig. F).
3. The charging display (d) flashes blue during charging.
4. Once the battery is fully charged, the charging display stops flashing.
Attaching and removing the suction tube / brushes / accessories
Slide the suction tube onto the opening of the handset until it clicks into place. To remove it, press the release
„
button and pull the suction tube away from the handset (fig. B).
The electric brush, mini electric brush and UV light brush must be powered for proper operation. These
„
attachments must therefore be mounted either on the suction tube or directly on the hand-held unit. To do this,
attach the respective attachment. To remove, press the release button and remove the attachment (fig. C).
All other accessories can be directly connected to the main unit or, to increase the appliance's reach, to the tube,
„
the extension hose and the multi-angle adapter.

Use

Switching the appliance on and off – boost button
Use the on/off button to switch the vacuum cleaner on and off (i). It continues operating until you
„
release the button. You can also use the locking lever for continuous operation.
Press the boost button (e) to maximise suction. When the appliance is switched off, boost mode is
„
automatically deactivated. You can also deactivate boost mode by pressing the boost button again.
Cleaning carpets and hard floors
Read the manufacture's care instructions before cleaning floors and carpets.
„
Rotating brushes can cause damage to some carpets and floors. Some carpets pill when cleaned with
„
rotating brushes. Test an inconspicuous area of the floor or carpet before cleaning it.
Before cleaning polished floors (wood, linoleum etc.) ensure that there are no foreign bodies on the
„
underside of the motorized power brush that might cause scratches.
Instruction manual
GB
27