Charging Station - Genius INVICTUS X9 Instrucciones De Uso

GB

Charging station

Specially designed for the space-saving and safe storage of the appliance. Remove the tube from the
main unit and place it on the charging station as illustrated (fig. G). There is a recess on the front side
for the motorized power brush (with or without tube) and 2 accessory holders.
Also has a battery charging function (See: Charging the battery).
Wall Mount
Affix the wall mount to the wall using the supplied screws. Ensure that there are no pipes or electric
cables behind the screw insertion points in the wall.
The recesses on the mount can be used for cable storage to prevent the charging cable from hanging on
the floor when not in use.
Emptying the dust container
1. Switch off the vacuum cleaner.
2. Empty the container when the maximum line is reached at the latest.
3. Hold the appliance with the dust container over a dustbin. Press the release of the dust container so
that the flap swings down and the dirt falls out (fig. H).
4. Close the lid properly.
Removing the cyclone/pre-motor and HEPA filter
NOTE!
RISK OF DAMAGE!
Improper handling of the device can cause damage to the device. Clean ALL filters regularly to maintain
suction power.
1. Switch of the vacuum cleaner.
2. Remove the dust container (fig. I) (please also refer to the 'Emptying the dust container' section).
3. Remove the cyclone filter (b) by turning it clockwise (fig. M).
4. Remove the pre-motor filter (c),by removing it from the top of the hand unit (fig. J).
5. Remove the HEPA filter (fig. K).
6. Clean the filters (please also refer to the 'Cleaning' section).
7. Put the filters back into the handset and reattach the dust container.
NOTE!
Replace the HEPA filter at intervals of approx. 6 months.
28
Instruction manual