Cleaning The Vacuum Cleaner; Troubleshooting; Technical Data - ECG VT 4120 Manual De Instrucciones

5. Rinse the fi lter in cold water and let the fi lter thoroughly dry out before replacing it in the dust
container. Do not wash the dust container fi lter in the washer. Do not use a hair dryer for drying, let the
fi lter dry by itself.
6. Replace the fi lter carefully in the dust container. NEVER use the vacuum cleaner without inserted fi lter.
7. Insert the dust container in the handheld vacuum cleaner.
WARNING: The suction opening must be always open and free of obstacles. Otherwise, the motor could
overheat and the appliance could be damaged.
Note: We recommend replacement of the fi lter every three to six months with a new one depending on
the frequency of use to guarantee top performance of the appliance.

Cleaning the vacuum cleaner

Make sure that the vacuum cleaner is not connected to the charger before cleaning.
Use soft and lightly damp cloth with a few drops of detergent to clean the vacuum cleaner. Never use solvents
or other abrasive cleaners.
Never immerse the vacuum cleaner or the adapter in water or any other liquid and do not place it under
running water.
GB

TROUBLESHOOTING

Problem
The handheld vacuum
cleaner does not work
The motorized brush of the
fl oor vacuum cleaner does
not work.
The handheld vacuum
cleaner does not collect dirt
or has weak suction power.
Dust escapes from the
handheld vacuum cleaner.
The battery does not hold
the charge.

TECHNICAL DATA

Vacuuming dry and wet dirt
Washable fi lter
Charging time: about 10 hours
Operating time: about 18 minutes
Dust container capacity: 400 ml
Charging battery indicator
Docking station
26
Cause
• The battery is empty.
• Faulty battery (does not hold the charge).
• Dirtied contacts between the appliance and
the charging contacts.
• Charging adapter is connected to an outlet
without voltage.
• The charger is connected.
• The blade fan wheel is clogged with dirt.
• Broken belt.
• The handheld vacuum cleaner is not properly
inserted.
• Dust container is full.
• You must clean or replace the dust container
fi lter.
• The vacuum cleaner battery is empty.
• Dust container is full.
• Incorrectly installed dust fi lter.
• Torn dust fi lter.
The battery is dead.
Correction
• Charge the appliance.
• The battery is dead.
• Clean the contacts.
• Check the fuses, use diff erent outlet.
• Disconnect the charger.
• Remove dirt from the blade wheel.
Cut carefully wrapped around hair, etc.
using. scissors.
• Call service.
• Insert the handheld vacuum properly.
• Empty the dust container.
• Remove the fi lter and check, if the
suction opening is not clogged. Clean
or replace fi lter.
• Charge the vacuum cleaner.
• Empty the dust container.
• Check proper insertion of the dust
fi lter.
• Replace the dust fi lter.
Call service.
Accessories: tapered nozzle
Nominal voltage: DC 12 V
Nominal input power: 85 W
Adapter:
AC 100–240 V, ~ 50/60Hz, 0,2 A
DC18 V — 200 m A