Hilti SF 2-A Manual De Instrucciones página 6

Obligation signs
Wear eye protection Wear a hard hat Wear ear protection Wear protective en
gloves
Wear breathing
protection
Symbols
Read the operating Volts Direct current Rated speed under
instructions before no load
use
Revolutions per Drilling without Return waste
minute hammering material for
recycling.
Location of identification data on the power tool
The type designation can be found on the type identification plate at the
base of the power tool and the serial number on the side of the casing.
Make a note of this data in your operating instructions and always refer to it
when making an enquiry to your Hilti representative or service department.
Type:
Generation: 01
Serial no.:
3
Printed: 24.03.2014 | Doc-Nr: PUB / 5174907 / 000 / 00