Mixtrax Settings; Connections/Installation - Pioneer MVH-S115UI Manual De Instrucciones

C:\Program Files (x86)\Adobe\AdobeFrameMaker12\Structure\xml\Pioneer\1.0\020Chapter.fm
PioneerTest.book Page 14 Tuesday, March 6, 2018 2:09 PM
Menu Item Description
BRIGHTNESS
[1] to [10] Change the display brightness.
The available setting ranges differ
depending on [DIM SETTING].

MIXTRAX settings

Menu Item
SHORT PLAYBCK
[1.0 MIN], [1.5 MIN], [2.0 MIN],
[2.5 MIN], [3.0 MIN], [OFF]
MIX PATTERN
[SOUND LEVEL]
[LOW PASS]
[RANDOM]
DISPLAY FX
[ON], [OFF]
CUT IN FX
[ON], [OFF]
14
En
Description
Select the length of the playback time.
Change the MIXTRAX special effects
according to the audio level.
The mix pattern changes according to
the sound level.
The mix pattern changes according to
the bass level.
The mix pattern changes randomly
according to the sound level mode and
low pass mode.
Set the MIXTRAX special effects on/off.
Turn the MIXTRAX sound effects on/off
while manually changing the tracks.

Connections/Installation

Connections
WARNING
• When speaker output is used by 4
channels, use speakers over 50 W
(maximum input power) and
between 4 Ω to 8 Ω (impedance
value). Do not use 1 Ω to 3 Ω
speakers for this unit.
• When rear speaker output is used by
2 Ω of subwoofer, use speakers over
70 W (maximum input power).
* Please refer to connections for a
connection method.
• The black cable is ground. When
installing this unit or power amp
(sold separately), make sure to
connect the ground wire first. Ensure
that the ground wire is properly
connected to metal parts of the car's
body. The ground wire of the power
amp and the one of this unit or any
other device must be connected to
the car separately with different
screws. If the screw for the ground
wire loosens or falls out, it could
result in fire, generation of smoke or
malfunction.
19_815ME_QRD3603(B6_Horizon)
Ground wire POWER AMP
Other devices
Metal parts of
(Another electronic
car's body
device in the car)
*1 Not supplied for this unit
Important
• When installing this unit in a vehicle
without an ACC (accessory) position
on the ignition switch, failure to
connect the red cable to the terminal
that detects operation of the ignition
key may result in battery drain.
ACC position No ACC position
• Use this unit with a 12-volt battery
and negative grounding only. Failure
to do so may result in a fire or
malfunction.
• To prevent a short-circuit,
overheating or malfunction, be sure
to follow the directions below.
– Disconnect the negative terminal
of the battery before installation.
– Secure the wiring with cable
clamps or adhesive tape. Wrap
MVH-S115UI