Troubleshooting - MCS Master BCF 230RB Manual De Instrucciones

►►6. TROUBLESHOOTING
FAULT
The display 1. No power supply
does not work
2. Defective equipment
There is no 1. Obstructed air vents
air flow or it is
very low
2. Defective equipment
The device 1. Defective equipment
does not re-
spond to the
commands
The device 1. The water supply pipe is
leaks water
2. The water drain is dirty
3. The tank leaks
4. The panel is dripping
Figures and texts of this book are protected by COPYRIGHT.
CAUSE
loose
SOLUTION
1a. Make sure that the device is con-
nected to the power supply
1b. Make sure that the display is con-
nected to the cable
1c. Contact a support centre
2. Contact a support centre
1a. Remove any objects from the air
vent
1b. Contact a support centre
2. Contact a support centre
1. Contact a support centre
1. Tighten the fitting
2. Contact a support centre
3. Contact a support centre
4. Contact a support centre
en