LEMAN PON400 Manual De Instrucciones página 67

2. To tighten the tracking tension, the tracking screw is rotated clockwise while holding
its nut in place with a 7/16" open end wrench (not supplied).To loosen the tracking
tension, the tracking screw is rotated counterclockwise while the nut is held with the
wrench.
3. If the converyor feed belt is tracking towards the inboard (motor side) of the machine,
tighten (add tension) to the tracking adjustment screw on that side of the machine.
NOTE: Due to the width of the conveyor feed belt, tracking adjustments may not
become apparent immediately! Increase the speed of the conveyor feed belt to
hasten the effects of your adjustments. Make small measured corrections of
Figure 11
Figure 12
１６
EN
MS3140 DRUM SANDER