Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
convevor feed belt tracking adjustment screws in a counterclockwise direction.
6. Remove the used conveyor feed belt by grasping both sides of the belt . Gently lift
the conveyor table as you slide off the conveyor feed belt. If the belt will not move,
further reduve the tension on the feed belt and ensure you are lifting the table high
enough to allow the feed belt to slide off .
7. To installthe replacement conveyor feed belt, follow Steps 6 through 3 in reverse
order. Center the new feed belt on the conveyor feed belt table and evenly tension
the new feed belt using the inboard and outboard tracking adjusters. If you have
experience tracking problems, consult the Convevor Feed Belt Tracking Adjustment
secton.
WIRE DIAGRAM ( 230V/50Hz, 1 phase)
WIRE DIAGRAM ( 380V/50Hz, 3 phase)
２３
EN
MS3140 DRUM SANDER
Publicidad
Tabla de contenido
