EHEIM skimmarine300 Manual De Instrucciones página 15

English
The appliance must not run dry. It must only be used for liquids from +4°C up to
a maximum of +35°C.
Do not carry the appliance by the mains cable, and to disconnect from the
mains, always pull on the plug and not on the cable or appliance.
Protect the mains cable against heat, oil and sharp edges.
Only carry out the work described in these instructions.
Only use original spare parts and accessories for the appliance.
-
at least 30 cm
between the implant and magnet.
The pump must be protected by a residual current protection device with a max-
imum rated residual current of 30 mA. Please contact an electrician if there are
any questions or problems.
In the event of water leakage or when the residual current protection device is
triggered, immediately disconnect all devices in the aquarium from the power
supply.
If they are not being used, always disconnect all devices in the aquarium from
the power supply before you install/remove any parts and before all cleaning and
maintenance work.
Protect the mains socket and mains plug against moisture.
It is recommended to form a drip loop with the mains cable to
prevent any water running along the cable to the mains socket.
The electrical data of the pump must match the data of the power
mains. This data is found on the type plate, the packaging and in these instruc-
tions.
The mains connection cable of the pump cannot be replaced. If the cable is
damaged, the pump must be scrapped.
15