Waeco PerfectPower PP500 Instrucciones De Uso página 8

Collected_MB-840.qxd
Unscrew red knurl nut (6) and fasten the ring
eye (10) of the red connecting cable.
Unscrew black knurl nut (7) and fasten the
ring eye (11) of the black connecting cable.
To start-up the inverter, connect the red
terminal (+) with the positive pole (+) of the
battery and the black terminal (-) with the
negative pole (-) of the battery.
Make sure that the poles are clean when
connecting the battery.
1 230 V AC output
2 "ON/OFF" control light-emitting diode
green
3 ON/OFF Switch
4 control light-emitting diode red
(overload- and undervoltage display)
5 Ventilator
6 Positive contact (red knurl nut)
7 Negative contact (black knurl nut)
8 Positive contact (red terminal)
9 Negative contact (black terminal)
10 Red ring eye
11 Black ring eye
Caution! Length and cross-section of the
connecting cable are synchronized to each
other! Do not modify without authorisation.
Make sure that the polarity will not be
exchanged! Reverse polarity connection will
blow the internal fuses. Exchange of fuses by
experts only!
The start-up can be done with the "ON/OFF"
switch. The green control light-emitting diode
"POWER" lights up in the switch position "ON".
Should the battery voltage falls below 10.7/21.4 V
during operation, an audible signal is emitted and
the red control light-emitting diode illuminates.
The inverter switches off if the battery voltage
drops further. When the heating is too strong, the
inverter switches off — the red control light-
emitting diode illuminates. Switch off the inverter
by means of the "ON/OFF"-switch. The inverter
can be switched on again after it has cooled
down. When operating the inverter during
longer period of time and with the largest load, it
24/06/03 13:03 Page 8
Preparation and connection of the inverter
Commissioning of the inverter
1 2 3
5 6 7
8 9
is recommendable to start the motor in order to
recharge the battery of the vehicle. The inverter
can be operated with the motor running or
switched off. However, the motor should not be
started if the inverter is switched on.
8
4
10 11