Controls And Operation - CEVIK CE-PROMIG 200 Manual De Instrucciones

EN
3. Protective gas leak affects welding performance.
4. Avoid exposing the gas bottle to the direct action of
the sun's rays and thus avoid a possible explosion of
the bottle due to the increasing pressure of the gas
caused by heat.
5. Place the bottle vertically on a stable surface
avoiding the risk of accidental fall.
6. Never hit the gas bottle or place it horizontally.
7. Ensure that no person is near the regulator, before
releasing the gas or closing the outlet.
8. The gas outlet flow meter must be installed
vertically to ensure accurate measurement.
9. Before connecting the gas regulator to the
equipment, open and close the gas passage several
times to eliminate possible dust in the filter and
ensure the correct gas flow.
10. Since the arc of the MIG weld is much stronger
than that of the MMA weld, wear a welding
helmet and protective clothing.
9. CONTROLS AND OPERATION OF MACHINE.
Turn on the machine with the mains power switch (10). Wait for the digital control program to load. Turn the
left knob (1), to choose language (English or Spanish).
Then press the Left button (3) and choose the welding process by turning the left knob (1), press it to confirm
the selection.
70