Electrical Safety - Berner BR-621 Manual De Uso

Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
BERNER repair agent.
20 Have your tool repaired by an
authorized BERNER repair agent
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety rules for cutters
• Always use cutters with a shank diameter
corresponding to the size of the collet
installed in your tool.
• Always use cutters suitable for a speed of
-1
30.000 min and marked accordingly.
• Never use cutters with a diameter exceeding
the maximum diameter indicated in the
technical data.
Package contents
The package contains:
1 Router
1 Parallel fence with fine adjustment and guide
rods
1 Collet 8 mm (GB: 1/4")
1 Guide bush 24 mm
1 Wrench # 17
1 Dust extraction plug
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Your BERNER high performance router BR-621
has been designed for professional heavy duty
routing of wood, wood products and plastics.
1 Lock-on/lock-off switch
2 Spindle lock
3 Collet nut
4 Parallel fence locking bolt
5 Guide rods for parallel fence
6 Dust extraction outlet in parallel fence
7 Fine adjuster for parallel fence
8 Parallel fence
9 Locking bolt
10 Router base
11 Finger guard
12 Revolver depth stop
13 Depth stop
15
14 Depth stop locking bolt
15 Plunge limiter
16 Quick adjuster for depth stop
17 Fine adjuster for depth stop
18 Dust extraction adaptor
19 Speed control dial (BR-621)
20 End lock

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power
supply corresponds to the voltage on the rating
plate.
Your BERNER tool is double insulated
in accordance with EN 50144;
therefore no earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and
you are competent to do this, proceed as
instructed below. If you are in doubt, contact
an authorized BERNER repair agent or
a qualified electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely;
a plug with bared copper conductors is
dangerous if engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved
plugs fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see below).
Brown is for Live (L) (2) and Blue is for
Neutral (N) (4).
• Before replacing the top cover of the mains
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable firmly
and that the two leads are correctly fixed at
the terminal screws.
E N G L I S H
en-3