Sammic SmartVide 5 Manual De Instrucciones página 11

Working with
the needle probe
Connect the needle
probe to the machine.
SET set temperature
of the needle probe
at which we want it to
warn us.
Press PLAY to store
data.
Peep, Peep...!!!
It has reached the temperature.
Indicates the time passed.
Press any button to cancel
the acoustic warning.
End!
SUMMARY of the cycle.
Press any button for a
new cycle.
Fault warning
Probe Stirrer motor
Water
temperature
Note: Call a Technical Service
Change °C/ °F (out of cycle)
1.- Machine off
2.- Holding down the SET
button, switch on the
machine.
3.- Change of unit.
Reset
1.- Machine off
2.- Push and hold "SET", "-" and "+", switch the
machine on.
3.- Hold for 10 seconds until the machine makes a
different noise.
4.- Turn off and on again.
1.- Machine off
2.- Holding down the "-" button, switch on the machine.
3.- Sound off.
1
2
9
10
11
Press END to finish
12
the cycle.
13
18
19
20
Heater
resistances
Water needed. Fill.
- 11 -
Properties
1.- % 100 memory full
3
4
2.- Date/time
3.- Bluetooth status
4.- Machine name
5.- Heating status
5
6.- Actual water temperature
6 7.- Estimated heating time
7
8.- Timer SET (target)
9.- Temperature SET (target)
8
21
10.- Timer status
11.- Timer countdown
12.- Temperature during the cycle
13.- Water heating kWh
14.- SET temperature graph
15.- Real temperature graph
14
16.- Cycle time elapsed
15
17.- kWh during the cycle
16
18.- Actual needle probe temperature
17
19.- Time elapsed
20.- SET needle probe temperature
21.- SET value safety status
Warnings
Power cut during the
cycle. Indicates time and
temperature before and
after the power cut
Calibration
1.- Machine off
2.- Holding down the – and + buttons, switch on the
machine.
3.- CALIBRATION screen in °C.
4.- Adjust the value with SET and the – and +
buttons.
5.- Turn off and on again.
Calibration
1.- In the App, set the SET necessary parameters.
2.- Send via Bluetooth to the SmartVide.
3.- Press Play to start it.
Sound off.
Closed Open
Overheating cab
EN