Programming Instructions - Fracarro DIGIFLEX SIG9808CI Instrucciones De Funcionamiento

output audio
adjustment
green led
red led
output video
adjustment
flat cable
connector
NOTE: when the boards 7 and 8 are used as modulator mode, the red LED will flash.
3.2 INSERT THE CAM IN THE SLOT COMMON INTERFACE
To insert and remove the CAM from the slot common interface of a Master or Stand-alone receiver, open the
headend front panel with the key and insert/remove the CAM (not supplied) in the slot common interface in
the bottom part of the receiver. Refer to Figure 6 and 7.
ATTENTION: when you use the CAM (not supplied), take note of the maximum operating temperature
declared by the manufacturer.
WARNING: scrolling the channel list the "encrypted program" message might be displayed, even if you own
the decoding rights. Wait a few seconds and the display and decoding will continue automatically (the video
display wait is directly dependent from the CAM).
WARNING: a few functions of the CAM are accessible only after they are enabled. For further information see
the CAM menu (menu: COMMON INTERFACE – CI MENU).
WARNING: The CAM can decrypt a limited number of channels, depending on the CAM features. This limit
must be considered when adding programs to the program list CI. If the number of channels exceeds the
number allowed from the CAM, there could be malfunctionings.
To program and display the internal status of the headend, use a TPE programmer. Each receiver must be
singularly programmed by setting all the parameters needed to find out the input TV program and to define the
output channel (in the VHF or UHF band). Connect the programmer to one of the two RJ45 plugs (see Fig. 1),
(please wait few seconds, while TPE is searching lines of device), when the TPE has reached to the number
of receivers press
shows the Fracarro logo. Press any key of the keyboard to access to the initial menu (except the
To set the TPE language, enter the "TPE SETUP" --> "LANGUAGE" menu. Choose the language by scrolling
with the arrows and confirm with the
vice), when the TPE has reached the number of receivers press
instruction sheet of the TPE programmer or to menu from page 27 to page 28. To enter the OSD (On Screen
FRONT VIEW OF RECEIVER
audio left
audio right
video
Fig. 15 Selection of TV receiver mode or modulator

4. PROGRAMMING INSTRUCTIONS

key, to have access to enter all the receivers; the TPE switches on automatically and
key. (Please wait few seconds, while TPE is searching lines of de-
Selection
SUB-D
15 pin
EXT
audio
left
TV
EXT
audio
right
ONLY FOR TV
MODULE
EXT
video
n° 7 & n° 8
TV
selection
EXT
audio
Audio & Video
left
TV
IN/OUT
EXT
audio
right
TV
EXT
video
TV
key. For other TPE settings, refer to the
25
TV
RECEIVER
MODE
MODULATOR
MODE
key).