Elvox 7200 Serie Instrucciones De Funcionamiento página 7

The monitor will remain in "SETTING" mode (green LED flashing)
until the arrow buttons are pressed. SETTING mode is cancelled
when the arrow buttons are not pressed for more than 5 seconds.
Nevertheless the user can exit this mode by pressing button
again until the green LED switches off.
Ringtone mute function
Ringtone mute is activated using the same procedure described
above for adjusting the ringtone volume. Once the volume has
been adjusted to the lowest setting by repeatedly pressing the
down arrow, the red LED
minates to indicate that ringtone mute is activated.
Melody programming of outdoor call
It is possible to choose the melody of outdoor call (call from lan-
ding). The available melodies are the same as the ones for the
call from speech unit.
In order to choose the melody of outdoor call it is necessary to
keep the push-buttons pressed for 2 seconds
the SETTING mode keep simultaneously pressed the push-but-
tons and
starts flashing (about 2 seconds). At this point use the push-but-
tons and
Once the melody has been chosen, wait until the monitor exit the
SETTING mode (switching off of green LED
in the bottom left-hand corner illu-
until the red LED below
to select the melody required.
).
E N G L I S H
Brightness and contrast control functions
These settings can be adjusted with the display switched on.
Press push-button
at the bottom left flashes. This LED normally serves as the
OPEN DOOR indicator. This flashing indicates entry into "SET-
TING" mode, during which buttons
used to set the contrast and buttons
select the brightness. When the maximum and minimum values
are reached, this is indicated by a beep. The monitor will remain in
"SETTING" mode (green LED flashing) until the arrow buttons are
pressed. SETTING mode is cancelled when the arrow buttons are
not pressed for more than 5 seconds. Nevertheless the user can
exit this mode by pressing button
LED switches off.
Communication mode selection function (
It is possible to choose between two different modes of commu-
nication with speech units or:
to enter
1. HANDS FREE mode: press the TALK/LISTEN push-button
at the start of the conversation only, to activate the
audio, and at the end of the conversation to deactivate the
audio. The "audio active" condition is indicated by the illumina-
tion of the red LED
tor, which is normally used to indicate RINGTONE MUTE.
for 2 seconds, until the green LED
and
and
again until the green
button)
at the bottom left corner of the moni-
can be
to