Elvox 7200 Serie Instrucciones De Funcionamiento página 8

2. PUSH-TO-TALK mode: keep the talk/listen push-button
pressed during the conversation; release it at the end
of the conversation.
The 7200 series monitor is factory set to HANDS FREE communi-
cation mode. To switch from one mode to the other, with the moni-
tor switched OFF press push-button
enter SETTING mode; simultaneously press and hold down push-
buttons and
starts flashing. At this point, while the LED is flashing, press the
TALK/LISTEN push-button
function is confirmed if the red LED switches off.
Automatic answer function
This function, which is only available in HANDS FREE mode, acti-
vates the monitor audio connection automatically when a call is
received from the speech unit, without the need to push the
TALK/LISTEN button
cated by the illumination of the red LED
corner of the monitor, which is normally used to indicate RINGTO-
NE MUTE. The audio is activated automatically 5 seconds after the
call is received. To enable this function, with the monitor switched
OFF press push-button
mode; simultaneously press and hold down push-buttons
and until the red LED underneath starts flashing.
for 2 seconds to
until the red LED underneath
. to confirm the change. The
. The "audio active" condition is indi-
at the bottom left
for 2 seconds to enter SETTING
E N G L I S H
At this point, while the LED is flashing, press the TALK/LISTEN
push-button
firmed if the red LED switches off. To disable this function, follow
the same procedure. If HANDS FREE mode was not active during
the enabling process, it will be activated automatically when the
AUTOMATIC ANSWER function is enabled. If the automatic
answer function is subsequently disabled, the HANDS FREE fun-
ction will remain active.
Adjusting the conversation volume
The term "conversation volume" refers to the perceived volume of
the caller's voice when he/she is standing in front of the speech
unit (entrance panel), or speaking through an intercommunicating
interphone or monitor. To adjust the conversation volume, the user
must be in communication with a speech unit or intercom device.
Press push-button
mode; once the green LED
the TALK/LISTEN push-button
with push-buttons
both in HANDS FREE mode and in PUSH-TO-TALK mode.
to confirm the change. The function is con-
for 2 seconds to enter SETTING
starts flashing, press and hold
and adjust the volume
and . This procedure applies