Fagor VCE-306 Manual De Instrucciones página 14

interior 14/5/04 16:02 Página 12
The electronic power regulator (8) enables you to
adjust the suction power in accordance with the floor
surface to be vacuumed. You can set the power
level to anywhere between Minimum (recommended
for curtains and delicate fabrics) and Maximum
(recommended for high dirt concentrations and hard
floor surfaces). In general, except in cases of
extreme dirt or delicate fabrics, we recommend that
you adjust the power setting to the energy-saving
position half way between MAX and MIN.
Suction power can also be regulated manually by
adjusting the shutter in the handle (13):
Shutter closed: greater suction power.
Shutter open: less suction power.
The floor brush (11) has two working positions:
A) position for vacuuming hard floor surfaces
B) position for vacuuming rugs and carpets
When you have finished using the vacuum cleaner,
switch it off, unplug the cable and press the automatic
cable rewind pedal (7). Make sure that the cable does
not twist or loop when rewinding. Guide manually if
necessary.
Storage: The appliance can be stored in an upright
position, inserting the telescopic tube catch (15) into the
housings located underneath the vacuum cleaner and at
the rear of the transport handle.
Nozzles 17 and 18 can be attached to the accessory
hook (16) located on the telescopic tube.
13