Technical Support Service; Emergencies; Scrapping The Machine; Ordering Spare Parts - Enofrigo GRACE 2 Manual De Instrucciones

The thermoregulator
does not work
correctly.
Gurgling and blowing noises caused by the refrigeration circuit are normal..

TECHNICAL SUPPORT SERVICE

You are advised to contact the manufacturer or authorised dealer who will carry out any
overhauling and repair work via specialist personnel using purposely designed equipment.
The data given in the identification plate (see chapter n° 5) must always be communicated
to the technical support service, in particular:
•
the type of fault;
•
the machine model;
•
the machine serial number;
•
your address;
•
your telephone number.

17. EMERGENCIES

Correct use of the machine ensures that emergency situations cannot occur during opera-
tion, cleaning and maintenance provided that the instructions given in this manual are fol-
lowed.
In the event of imminent danger, turn the main switch off, unplug the unit from the
socket interlocked with switch and call the manufacturer or authorised dealer to
request the services of a qualified technician.
If current dispersion occurs on contact with metal parts of the machine, turn the main
switch off, unplug the unit from the socket interlocked with switch and call the manufactu-
rer or authorised dealer to request the services of an electrician.

18. SCRAPPING THE MACHINE

At the end of its life, the machine must be disposed of in compliance with current local regu-
lations concerning industrial and special waste. It must also be made unserviceable by cut-
ting the electrical power supply cable, after disconnecting it.
In particular, do not allow the gas contained in the refrigeration system to be dispersed in
the environment; it must be taken to special refrigeration gas recovery centres.

19.ORDERING SPARE PARTS

Find out the code of the part that needs replacing.
Always provide the following information when ordering:
• Machine serial number (on the plate)
• Part reference number and code
• Quantity required
• Year of manufacture of the machine
• Most appropriate means of shipment
• Customer's address
The technical information provided in this manual is intended as a guide. The manufactu-
rer reserves the right to make changes at any time without notice.
27
The set values are not correct. Reset the thermoregulator.
CT81900001 Rev.01 – 07/13