Metal Cutting; Dust Extraction - Makita JV0600 Manual De Instrucciones

Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then tighten
the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
011966
For internal cutouts without a lead-in cut from an edge,
pre-drill a starting hole 12 mm (1/2") or more in diameter.
Insert the blade into this hole to start your cut.
B) Plunge cutting
011967
You need not bore a starting hole or make a lead-in
cut if you carefully do as follows.
(1) Tilt the tool up on the front edge of the base
with the blade point positioned just above the
workpiece surface.
(2) Apply pressure to the tool so that the front
edge of the base will not move when you
switch on the tool and gently lower the back
end of the tool slowly.
(3) As the blade pierces the workpiece, slowly
lower the base of the tool down onto the
workpiece surface.
(4) Complete the cut in the normal manner.
Finishing edges
011968
1. Starting hole
1
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.

Dust extraction

011969
Clean cutting operations can be performed by connecting
this tool to a Makita vacuum cleaner. Insert the hose of
the vacuum cleaner into the hole at the rear of the tool.
Rip fence (Optional accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before
accessories.
1. Straight cuts
011970
When repeatedly cutting widths of 160 mm or less,
use of the rip fence will assure, clean, straight cuts.
1
2
011971
To install, insert the rip fence into the rectangular
hole on the side of the base with the fence guide
facing down. Slide the rip fence to the desired
cutting width position, then tighten the bolt to
7
1. Hose
1
installing or removing
1. Rip fence
(Guide rule)
1
1. Bolt
2. Fence guide
3. Hex wrench
4. Rip fence (Guide
rule)
3
4